Home Automation 32A30 Manuel d'utilisateur

HOME AUTOMATION, INC. Model 32A30 Touchscreen Hub Installation Manual Document Number 32I30-1 Rev B March, 2008

32A32-2VIDEO ENCODERNYLON SPACER32A30-1, -2, -3, -4TOUCHSCREEN HUB

8. POWER CONNECTIONS The supplied Power Pack provides both touchscreen (24VDC) and camera (12VDC) power. An AC power outlet should be located withi

SPECIFICATIONS Operating 32 - 120 degrees F (0 - 49 degrees C) Ranges: 10 - 85 % relative humidity, non-condensing Power Pack: Out

Copyright © 2005-2008 Home Automation, Inc. All Rights Reserved

INTRODUCTION The HAI Touchscreen Hub is used to provide power, communications, and a video signal to HAI OmniTouch touchscreens. Up to eight (8) Omn

INSTALLATION NOTE: This unit has protection against static discharge in normal operation. However, use static discharge precautions during installat

CAMERAINPUTTERMINATINGRESISTORJUMPERCAMERA OUTPUTCAMERA POWER1.5A MAXIMUMZONE(+)ZONE(-)HAI CONTROLLERGND(GROUND)B / GREENA / YELLOWGND MUST BE CONNEC

3. LOW BATTERY INDICATOR (Optional Connection) When the backup batteries connected to the Touchscreen Hub become depleted, there are terminals on th

Connecting to OmniTouch (32A00-1) When connecting a standard OmniTouch to the Touchscreen Hub, it is very important to plan where the OmniTouch touch

5. CAMERA CONNECTIONS The Touchscreen Hub takes the composite signal from any NTSC camera, digitizes it through the encoder, and then broadcasts it

6. CONNECTING A SECOND HAI TOUCHSCREEN HUB When connecting more than 8 OmniTouch with Video touchscreens to an HAI OmniPro II or HAI Lumina Pro cont