Home-automation RC-1000 Manuel d'utilisateur

11 RC-1000 Thermostat Installation Instructions DESCRIPTION The RC-1000 is a precision digital thermostat designed for 24 VAC he

1100 HAI HOME CONTROL SYSTEMS The thermostat can be connected to an HAI Home Control system. The controller can send commands to the thermostat to c

1111 REMOTE SETBACK SWITCH The thermostat can be connected to a remote switch to toggle the desired heat and cool temperature settings between preset

1122 REMOTE TEMPERATURE SENSOR A remote temperature sensor can be installed to monitor the temperature from a remote location or can be combined with

1133 DISABLE LOCAL CONTROL The Task Buttons and Scroll Wheel on the thermostat can be disabled to prevent anyone from controlling the thermostat loca

1144 SETUP AND CONFIGURATION NOTE: For proper operation of the features of this thermostat, the Time and Date must be set. Even when connected t

1155 System Options Note: Before operating the thermostat, the “System Type” and “System Mode” must be configured. The thermostat can be configured

1166 Cool/Heat Min On/Off These items are used to limit the on and off times of the cooling and heating system (in minutes). Cool Minimum On The n

1177 Auxiliary Heat Differential: This determines how far from the setpoint the temperature has to be before the auxiliary heat turns on. This is o

1188 Temperature Sensors The Temperature Sensor settings are used to configure the internal temperature sensor and an optional remote temperature sen

1199 TROUBLESHOOTING TIPS SYMPTOM ACTION TO TAKE Thermostat Dead 1. Check power to the thermostat 2. Check wiring diagrams SYMPTOM ACTION TO

22 Location When replacing an existing thermostat, install the RC-1000 in the same location. If the existing location doesn't meet the followin

2200 LIMITED WARRANTY HAI warrants this product against defects in material and workmanship, under normal use and service, for a period of two (2) ye

33 Connect each wire to the terminal strip(s) on the thermostat base per the wiring diagram for your system application - See Figures 4 - 7. Form t

44 TYPICAL WIRING DIAGRAMS CAUTION: Do not short gas valve, fan, heat relay, or cool relay...even momentarily. Do not attempt to h

55 3. When configured as a conventional thermostat, by default this thermostat does not turn the fan on with a call for heat. If the furnace require

66 Single Stage Conventional 24VAC "HOT"Heat24VAC Common*FanCoolUP24VACCONTROLTRANSMFOMERFan RelayCool RelayHeat RelayHVAC SYSTEMTHERMOSTAT

77 About Heat Pump Systems 1) Terminal 5 (O) is energized for cooling Terminal 6 (B) is energized for heating In most applications, the reversing

88 Heat Pump (2 Stage Heat / 1 Stage Cool) 24VAC Common24VAC "HOT"Auxilirary HeatCompressorGround FaultFanCompressor RelayAux Heat RelayFan

99 REMOTE SYSTEM WIRING DIAGRAMS This thermostat has been preprogrammed with energy saving program schedules. When used with a remote system, HAI re